Automated nondestructive assay of UF6 cylinders: Detector characterization and initial measurements

作者：Mace E K^*; Smith L E

来源：Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment , 2011, 652(1): 62-65.

DOI：10.1016/j.nima.2010.09.149

• Nondestructive assay
• Nuclear fuel cycle
• Safeguards
• UF6

International Atomic Energy Agency (IAEA) inspectors currently perform periodic inspections at uranium enrichment plants to verify UF6 cylinder enrichment declarations. Measurements are typically performed with handheld high-resolution sensors on a sampling of cylinders taken to be representative of the facility's entire cylinder inventory. These measurements are time-consuming and assay only a small fraction of the total cylinder volume. An automated nondestructive assay system capable of providing enrichment measurements over the full volume of the cylinder could improve upon current verification practices in terms of manpower and assay accuracy. Pacific Northwest National Laboratory is developing an Integrated Cylinder Verification System (ICVS) intended for this purpose and has developed a field prototype of the nondestructive assay (NDA) components of an ICVS. The nondestructive assay methods would combine the "traditional" enrichment-meter signature (i.e. 186-keV emission from U-235) as well as "nontraditional" high-energy photon signatures derived from neutrons produced primarily by F-19(alpha,n) reactions. This paper describes the design, calibration and characterization of the NaI(Tl) and LaBr3(Ce) spectrometers utilized in the field prototype. An overview of a recent field measurement campaign is then provided, supported by example gamma-ray pulse-height spectra collected on cylinders of known enrichment.

• 出版日期2011-10-1