A dislocation density based elasto-plastic self-consistent model for the prediction of cyclic deformation: Application to AA6022-T4

作者：Zecevic Milovan; Knezevic Marko

来源：International Journal of Plasticity, 2015, 72: 200-217.

DOI：10.1016/j.ijplas.2015.05.018

• Bauschinger effect
• Residual stress
• Cyclic loading
• Dislocations
• Crystal plasticity

We develop a polycrystal plasticity constitutive law based on the elasto-plastic self-consistent (EPSC) theory for the prediction of cyclic tension-compression deformation. The crystallography based model integrates a dislocation based hardening model and accounts for inter-granular stresses and slip system level backstresses, which make it capable of capturing non-linear unloading and the Bauschinger effect (BE). Furthermore, the model features dissolution of dislocation population upon the load reversal, which enables it to predict the change in hardening rate during reverse loading from that during forward loading. To demonstrate these capabilities of the model, we investigate elasto plastic behavior of AA6022-T4 sheets under in-plane cyclic tension compression. From a set of carefully performed cyclic tests to several strain levels, we observe that the material exhibits (1) a typical decreasing hardening rate during forward loading, (2) a linear followed by non-linear unloading upon the load reversal, (3) a transient softening followed by rapid work hardening (the BE), and (4) a decrease in subsequent hardening rate during reverse loading (the permanent softening phenomenon). To predict these effects, we calibrate the model to establish a set of material parameters using a portion of the measured data. The remaining measured data is used for verification of the model. We show that using the single set of material parameters, the developed model is capable of predicting all the particularities pertaining to the cyclic deformation of the material with great accuracy. From the favorable comparison of the predictions and experimental data, we infer first that the non-linearity of unloading increases with the amount of pre-strain, next that the backstresses have a dominant effect in capturing non-linear unloading while both the backstresses and inter-granular stresses govern the BE, and finally that the inclusion of reversible dislocation motion is the key for capturing hardening rates during reverse loading.

• 出版日期2015-9