Analytic study of the onset of plastic necking instabilities during biaxial tension tests on metallic plates

作者：Jouve Dominique^*

来源：European Journal of Mechanics - A: Solids , 2015, 50: 59-69.

DOI：10.1016/j.euromechsol.2014.10.002

• Plastic necking instabilities
• Biaxial tension tests
• Linear stability analysis

In this article, we study the onset of the development of plastic necking instabilities during dynamic tension tests on metallic plates biaxially loaded in their plane. This model applies whatever the thickness. The material is supposed to be homogeneous, isotropic, incompressible, elastoviscoplastic, to satisfy Von Mises' plasticity criterion and normality flow rule (damage and heat conduction are neglected). As Dudzinski and Molinari did in 1988 for static tests on very thin plates in the framework of generalized plane stress theory (thickness is supposed to vary slowly and slightly along loading directions) (Instabilite de la deformation viscoplastique en chargement biaxial, 1988, Compte Rendu a l'Academie des Sciences de Paris 307, serie 2, pages 1315-1321), we carry out a linear stability analysis. The flow is viewed as the sum of the mean homogeneous flow of the perfect plate, and of small perturbations delta(nu) over right arrow of the velocity field, periodic along the x(1)- and x(2)- loading directions, growing exponentially. We search for the most unstable pair of wavelengths (lambda((d))(1), lambda((d))(2)) and for the associated growth-rate theta((d)) (the dominant mode). Plastic deformation concentrates preferably along zero rate extension lines for non positive velocity gradient ratio alpha = D-22/D-11 (D denoting deformation rate tensor), and along lines parallel to minor principal stress direction for biaxial stretching (alpha > 0). For sufficiently viscous materials, inertia plays a negligible role (maximum plastic strain-rate considered in this paper equals 20s(-1), and thickness does not exceed 2 cm), the wavelength associated with the dominant mode is much greater than thickness, and Dudzinski and Molinari's model gives the associated growth-rate very accurately. This growth-rate is a root of a polynomial equation, that we re-establish starting from the equations of our 3D model. For non viscous materials, inertia is no longer negligible for non positive values of a.

• 出版日期2015-4
• 单位中国地震局