Atomic Layer Deposition of AlF3 Using Trimethylaluminum and Hydrogen Fluoride

作者：Lee Younghee; DuMont Jaime W; Cavanagh Andrew S; George Steven M^*

来源：Journal of Physical Chemistry C, 2015, 119(25): 14185-14194.

DOI：10.1021/acs.jpcc.5b02625

The atomic layer deposition (ALD) of AlF3 was, demonstrated using trimethylaluminum (TMA) and hydrogen fluoride (HF). The HF source was HF-pyridine. In situ quartz crystal microbalance (QCM), quadrupole mass spectrometer (QMS), and Fourier transform infrared (FTIR) spectroscopy measurements were used to study AlF3 ALD. The AlF3 ALD film growth was examined at temperatures from 75 to 300 degrees C. Both the TMA and HF reactions displayed self-limiting behavior. The maximum mass gain per cycle (MGPC) of 44 ng/(cm(2) cycle) for AlF3 ALD occurred at 100 degrees C. The MGPC values decreased at higher temperatures. The MGPC values were negative at T > 250 degrees C when TMA and HF were able to etch the AlF3 films. Film thicknesses were also determined using ex situ X-ray reflectivity (XRR) and spectroscopic ellipsometry (SE) measurements. The AlF3 ALD growth rate determined by the ex situ analysis was 1.43 angstrom/cycle at 100 degrees C. These ex situ measurements were in excellent agreement with the in situ QCM measurements. FTIR analysis monitored the growth of infrared absorbance from Al-F stretching vibrations at 500-900 cm(-1) during AlF3 ALD. In addition, absorption peaks were observed that were consistent with AlF(CH3)(2) and HF species on the surface after the TMA and HF exposures, respectively. X-ray photoelectron spectroscopy (XPS) and Rutherford backscattering spectrometry (RBS) measurements revealed that the deposited films were nearly stoichiometric AlF3 with an oxygen impurity of only similar to 2 at %. AlF3 ALD may be useful for a number of applications such as ultraviolet optical films, protective coatings for the electrodes of Li ion batteries, and Lewis acid catalytic films.

• 出版日期2015-6-25