Dust Explosion Characteristics of Aluminum, Titanium, Zinc, and Iron-Based Alloy Powders Used in Cold Spray Processing

作者：Sakata K^*; Tagomori K; Sugiyama N; Sasaki S; Shinya Y; Nanbu T; Kawashita Y; Narita I; Kuwatori K; Ikeda T; Hara R; Miyahara H

来源：Journal of Thermal Spray Technology, 2014, 23(1-2): 123-130.

DOI：10.1007/s11666-013-0043-4

• aluminum
• carbonyl iron
• cold spray
• dust explosion
• eutectoid steel
• risk assessment
• scanning electron microscopy
• titanium
• x-ray diffraction
• zinc

Compared to conventional thermal spray coating, cold spray processing typically employs finer, smaller-diameter metal powders. Furthermore, cold-sprayed particles exhibit fewer surface oxides than thermally sprayed particles due to the absence of particle melting during spraying. For these reasons, it is important to consider the potential for dust explosions or fires during cold spray processing, for both industrial and R%26D applications. This work examined the dust explosion characteristics of metal powders typically used in cold spray coating, for the purpose of preventing dust explosions and fires and thus protecting the health and safety of workers and guarding against property damage. In order to safely make use of the new cold spray technology in industrial settings, it is necessary to manage the risks based on an appropriate assessment of the hazards. However, there have been few research reports focused on such risk management. Therefore, in this study, the dust explosion characteristics of aluminum, titanium, zinc, carbonyl iron, and eutectoid steel containing chromium at 4 wt.% (4 wt.% Cr-eutectoid steel) powders were evaluated according to the standard protocols JIS Z 8818, IEC61241-2-3(1994-09) section 3, and JIS Z 8817. This paper reports our results concerning the dust explosion properties of the above-mentioned metal powders.

• 出版日期2014-1