Drop impact onto a thin film: Miscibility effect

作者：Chen, Ningli; Chen, H.; Amirfazli, A.^*

来源：Physics of Fluids, 2017, 29(9): 092106.

DOI：10.1063/1.5001743

• SINGLE DROP
• CROWN FORMATION
• LIQUID-FILMS
• SURFACES
• DYNAMICS

In this work a systematic experimental study was performed to understand the process of liquid drop impact onto a thin film made of a different liquid from drop. The drop and film liquids can be miscible or immiscible. Three general outcomes of deposition, crown formation without splashing, and splashing, were observed in the advancing phase of the drop impact onto a solid surface covered by either a miscible or an immiscible thin film. However, for a miscible film, a larger Weber number and film thickness are needed for the formation of a crown and splashing comparing with immiscible cases. The advancing phase of drop impact onto a thin immiscible film with a large viscosity is similar to that of drop impact onto a dry surface; for a miscible film viscous film, the behavior is far from that of a dry surface. The behavior of liquid lamella in the receding phase of drop impact onto a thin miscible film is reported for the first time. The results show that immiscibility is not a necessary condition for the existence of a receding phase. The existence of a receding phase is highly dependent on the interfacial tension between the drop and the film. The miscibility can significantly affect the receding morphology as it will cause mixing of the two liquids. Published by AIP Publishing.

• 出版日期2017-9
• 单位南京航空航天大学