A Bayesian approach to the determination of ignition delay

作者：Bodisco Timothy^*; Choy Samantha Low; Brown Richard J

来源：Applied Thermal Engineering, 2013, 60(1-2): 79-87.

DOI：10.1016/j.applthermaleng.2013.06.048

• Ignition delay
• Diesel engine
• Bayesian modelling
• Markov-chain Monte Carlo
• Net rate of heat release

A novel in-cylinder pressure method for determining ignition delay has been proposed and demonstrated. This method proposes a new Bayesian statistical model to resolve the start of combustion, defined as being the point at which the band-pass in-cylinder pressure deviates from background noise and the combustion resonance begins. Further, it is demonstrated that this method is still accurate in situations where there is noise present. The start of combustion can be resolved for each cycle without the need for ad hoc methods such as cycle averaging. Therefore, this method allows for analysis of consecutive cycles and inter-cycle variability studies. Ignition delay obtained by this method and by the net rate of heat release has been shown to give good agreement. However, the use of combustion resonance to determine the start of combustion is preferable over the net rate of heat release method because it does not rely on knowledge of heat losses and will still function accurately in the presence of noise. Results for a six-cylinder turbo-charged common-rail diesel engine run with neat diesel fuel at full, three quarters and half load have been presented. Under these conditions the ignition delay was shown to increase as the load was decreased with a significant increase in ignition delay at half load, when compared with three quarter and full loads.

• 出版日期2013-10-2