科研之友
微信
新浪微博
Facebook
分享链接
摘要
Simple Summary: Claw conformation is commonly measured in cattle. It can be measured at cow-side or, by using digital images, on a computer. This study compared, for five conformational features of the claw, measurements made directly from the hoof with those made from a digital image of the same claw. Of the five measures, only one, toe angle, had results where agreement was good enough for the two measurements to be used interchangeably. The variation in differences between the digital and manual results for the other four measures was too great for them to be used interchangeably. When measuring claw conformation, more attention needs to be paid to the method used and it should not just be assumed that a different technique would have produced the same result. Abstract: Five measurements of claw conformation (toe angle, claw height, claw width, toe length and abaxial groove length) taken directly from the hoof were compared with the measurements taken from digital images of the same claws. Concordance correlation coefficients and limits-of-agreement analysis showed that, for four of the five measures (claw height, claw width, toe length and abaxial groove length), agreement was too poor for digital and manual measures to be used interchangeably. For all four of these measures, Liao's modified concordance correlation coefficient (mCCC) was <= 0.4, indicating poor concordance despite Pearson's correlation being >0.6 in all cases. The worst concordance was seen for toe length (mCCC = 0.13). Limits-of-agreement analysis showed that, for all four measures, there was a large variation in the difference between the manual and digital methods, even when the effect of mean on difference was accounted for, with the 95% limits-of-agreement for the four measures being further away from the mean difference than 10% of the mean in all four cases. The only one of the five measures with an acceptable concordance between digital and manual measurement was toe angle (mCCC = 0.81). Nevertheless, the limits-of-agreement analysis showed that there was a systematic bias with, on average, the manual measure of toe angle, being 2.1 degrees smaller than the digital. The 95% limits-of-agreement for toe angle were +/- 3.4 degrees, probably at the upper limit of what is acceptable. However, the lack of data on the variability of individual measurements of claw conformation means that it is unclear how this variability compares to measurement of toe angle in the same animal using the same or a different manual technique.
- 出版日期2015-9
- 单位甘肃农业大学
