科研之友
微信
新浪微博
Facebook
分享链接
摘要
This paper presents a new pulse generator for cutting of polycrystalline diamond (PCD) by micro wire electrical discharge machining (micro wire-EDM). The pulse generator using anti-electrolysis circuitry and digital signal processor-based pulse control circuit was developed to suppress damages on the machined surface of PCD while achieving stable machining. A novel pulse control method was proposed to provide high-frequency pulse control signals with a period of off duty cycle for reionization of the dielectric in the spark gap so as to reduce the consecutive occurrence of short circuits. A series of experiments were carried out to investigate the effect of open voltage on machining performance in terms of material removal rate, slit width, thickness of the damaged layer on machined surface, and surface finish. An increase of open voltage increases peak current, thus producing greater discharge energy and, thereby, contributing to improvements in material removal rate, but leading to larger slit width and thickness of the damaged layer and worse surface finish. Experimental results not only demonstrate that the developed pulse generator could achieve satisfactory machining results but also have verified the applicability of this new technique in micro wire-EDM.
- 出版日期2013-6
