Aluminum Foil Forming Limitation Test and Numerical Simulation

作者：Chen Weiye; Zou Tianxia; Tang Ding; Guo Feipeng; Li Dayong^*

来源：Journal of Shanghai Jiaotong University, 2018, 52(9): 1081-1085.

DOI：10.16183/j.cnki.jsjtu.2018.09.011

• Bulging tests
• Failure criteria
• Finite element simulations
• Forming limit diagrams
• Forming performance
• Strain acceleration
• UV printing
• Width thickness ratio

Thinner aluminum foil brings bigger challenge to its forming performance, so in this paper, no-damage UV printing technology was applied to marking grid in specimens, and an FLD test for 0.11 mm 8011-H22 aluminum foils was successfully launched. Because aluminum foil deformed very little in the width direction under the big width-thickness ratio and the effect of friction, only the right part of FLD could be obtained. Then the finite element simulation of rigid model bulging test was established, and the left part of FLD could be further completed based on the "strain acceleration"failure criteria. A complete FLD was then finally established.

• 出版日期2018
• 单位上海交通大学