科研之友
微信
新浪微博
Facebook
分享链接
摘要
A systematic study on the modification of optical properties in mechanically milled ZnO powder has been reported here. The average grain size of the powder becomes similar to 20 nm within 4 h of milling. Fluctuations of average grain size have been noticed at the initial stage of milling (within 15 min). Changes in grain morphology with milling have also been noticed in scanning electron micrographs of the samples. Room temperature optical absorption data shows a systematic red shift of absorption band edge (similar to 3.25 eV). The band tail parameter (extracted from the optical absorption just below the band edge) follows a simple exponential relation with the inverse of the average grain size. Significant increase of the band tail parameter has been noticed at low grain size regime. It has been analyzed that high values of band tail parameter is a representative of V-Zn-V-O type divacancy clusters. Room temperature photoluminescence spectra show decrease (except for 120 min milling) of band edge emission intensity with increase of milling time. Subsequent decrease of sub-band edge emission is, however, less prominent. The variation of PL intensity ratio (intensity at band edge peak with that at 2.3 eV) follows simple exponential decrease with the increase of band tail parameter. This indeed shows that band edge emission in ZnO is related with the overall disorder in the system, not grain size induced only.
- 出版日期2012-1
