科研之友
微信
新浪微博
Facebook
分享链接
摘要
Ti-51 Pd-30 Ni-19 alloy was prepared in a different heat treatment state for retaining different dynamic mechanical properties. It has been found that specimens annealed at 1273 K followed by furnace cooling or by quenching exhibit different phase transformation behaviour. Subsequent annealing at lower temperature (after rolling) does not change the transformation sequence. DMTA (dynamic mechanical thermal analysis) measurement results reveal that the variation of the elastic modulus is different for the two kinds of transformation, which show elasticity softening and elastic step, respectively. The elastic modulus of low-temperature martensite differs as well. It has been found that damping of the peaks occurs on both heating and cooling the alloy across the phase transformation temperatures. The damping properties, tan delta, of the new phase possess higher values than those of the parent phase.
- 出版日期2002-8
- 单位上海交通大学
