科研之友
微信
新浪微博
Facebook
分享链接
摘要
The ability to accurately determine the metal content of crude oils is necessary for reasons ranging from the need to identify the source of the oils (Ni and V) to removing components that might inhibit catalysis during refining or impact negatively on the environment during hydrocarbon combustion. Here we show that ashing followed by chemical oxidation and acid digestion, coupled with ICP-MS analysis, provides an accurate method for determining the concentration of metals in crude oil. Nickel and vanadium concentrations were measured in certified Ni and V oil standards and in various light, intermediate and heavy crude oils after application of a single vessel ashing-chemical oxidation-acid digestion sample preparation and storing technique. Prior to the ashing, chemical oxidation and acid digestion, an aliquot of the crude oil was placed in a 10 ml Pyrex T culture tube and capped with quartz wool. The capped culture tubes were then subjected to thermal combustion, followed by chemical oxidation and leaching. The leachates and the aqueous standards were diluted and analyzed for their Ni and V contents using inductively coupled plasma mass spectrometry (ICP-MS).
The measured concentrations of Ni in oil standards, reported to contain 1, 100, and 1000 mg kg(-1) Ni (+/- 2% error), were 1.1 +/- 0.01, 99.8 +/- 1.46, and 1025 +/- 24 mg kg(-1) respectively. The corresponding concentrations of V in these standards, reported to contain 2, 100, and 1000 mg kg(-1) V, were measured to be 1.93 +/- 0.06, 104 +/- 1.3, and 1027 +/- 7.5 mg kg(-1), respectively. Crude oil samples, A, B, C, D and E, that varied significantly in their composition, and ranged from light to heavy, were determined to contain 5.59 +/- 0.32, 4.05 +/- 0.03, 6.22 +/- 0.22, 33.8 +/- 0.7 and 41.6 +/- 3.5 mg kg(-1) Ni, respectively. Their V contents were determined to be 11.98 +/- 0.1, 12.2 +/- 0.1, 16.5 +/- 0.4, 34.7 +/- 0.4, and 104 +/- 8.9 mg kg(-1), respectively. The results were thus repeatable on average to 4.1% and 2.75% for Ni and V, respectively; the repeatability was worst (similar to 8.5%) for crude oil E, a heavy (viscous) oil with a very high asphaltene content (27.2%).
This modified single vessel ashing-digestion technique (combustion, chemical oxidation, acid leaching and storing) minimizes contamination and significantly reduces the loss of ash. Our results are repeatable, comparable to, and in some cases superior to those of other methods. The method is applicable to a wide range of crude oil compositions, is very accessible and robust, easy to use, and does not require costly equipment in preparing the samples for analysis by ICP-MS.
- 出版日期2018-3-9
- 单位McGill
