科研之友
微信
新浪微博
Facebook
分享链接
摘要
The determination of water in various matrices is one of the most important analytical measurements. We report on a high-resolution capacitance-based moisture sensor utilizing a thin film of a perfluorosulfonate ionomer (PFSI)-H3PO4 composite in a flow-through configuration, for both gas and liquid samples. Incorporation of H3PO4 into a PFSI sensing film improved the limit of detection (LOD) (signal-to-noise ratio, S/N = 3) by a factor of 16 in the gas phase to 0.075% relative humidity (RH) (dew point = -56 degrees C). The response time was dependent on the sensing film thickness and composition and was as low as similar to 60 ms. The temperature dependence of the sensor response, and its relative selectivity over alcohol and various other solvents, are reported. Measurement of water in organic solvents was carried out in two different ways. In one procedure, the sample was vaporized and swept into the detector (e.g., in a gas chromatograph (GC) without a column); it permitted a throughput of 80 samples/h. This is well-suited for higher (%) levels of water. In the other method, a flow injection analysis system integrated to a tubular dialysis membrane pervaporizer (PV-FIA) was used; the LOD for water in ethanol was 0.019% (w/w). We demonstrated the temporal course of drying of ethanol by Drierite; the PV-FIA results showed excellent correspondence (r(2) %26gt; 0.99) with results from GC-thermal conductivity detection. The system can measure trace water in many types of organic solvents; no reagent consumption is involved.
- 出版日期2012-10-16
