Accuracy of laser-scanned models compared to plaster models and cone-beam computed tomography

作者：Kim Jooseong; Heo Giseon; Lagravere Manuel O^*

来源：The Angle Orthodontist, 2014, 84(3): 443-450.

DOI：10.2319/051213-365.1

• Cone-beam computed tomography
• Digital models
• Plaster models

Objective: To compare the accuracy of measurements obtained from the three-dimensional (3D) laser scans to those taken from the cone-beam computed tomography (CBCT) scans and those obtained from plaster models.
Materials and Methods: Eighteen different measurements, encompassing mesiodistal width of teeth and both maxillary and mandibular arch length and width, were selected using various landmarks. CBCT scans and plaster models were prepared from 60 patients. Plaster models were scanned using the Ortho Insight 3D laser scanner, and the selected landmarks were measured using its software. CBCT scans were imported and analyzed using the Avizo software, and the 26 landmarks corresponding to the selected measurements were located and recorded. The plaster models were also measured using a digital caliper. Descriptive statistics and intraclass correlation coefficient (ICC) were used to analyze the data.
Results: The ICC result showed that the values obtained by the three different methods were highly correlated in all measurements, all having correlations >0.808. When checking the differences between values and methods, the largest mean difference found was 0.59 mm +/- 0.38 mm.
Conclusions: In conclusion, plaster models, CBCT models, and laser-scanned models are three different diagnostic records, each with its own advantages and disadvantages. The present results showed that the laser-scanned models are highly accurate to plaster models and CBCT scans. This gives general clinicians an alternative to take into consideration the advantages of laser-scanned models over plaster models and CBCT reconstructions.

• 出版日期2014-5