Distortion and Residual Stress in High-Pressure Die Castings: Simulation and Measurements

作者：Hofer P^*; Kaschnitz E; Schumacher P

来源：JOM, 2014, 66(9): 1638-1646.

DOI：10.1007/s11837-014-1118-5

Two individual high-pressure die casting geometries were developed to study the influence of process parameters and alloy composition on the distortion behavior of aluminum alloy castings. These geometries, a stress lattice and a V-shaped lid, tend to form residual stress due to a difference in wall thickness and a deliberate massive gating system. Castings were produced from two alloys: AlSi12(Fe) and AlSi10MnMg. In the experimental castings, the influence of important process parameters such as die temperature, ejection time, and cooling regime was examined. The time evolution of process temperatures was measured using thermal imaging. Subsequent to casting, distortion was measured by means of a tactile measuring device at ambient temperatures. The measured results were compared against a numerical process and stress simulations of the casting, ejection, and cooling process using the commercial finite element method software ANSYS Workbench. The heat transfer coefficients were adapted to the temperature distributions of the die, and the castings were observed by thermal imaging. A survey of the results of the comparison between simulation and experiment is given for both alloys.

• 出版日期2014-9