A 1-dimensional dynamic model for a sorption-compressor cell

作者：Wu, Y.^*; Mulder, T.; Vermeer, C. H.; Holland, H. J.; ter Brake, H. J. M.

来源：International Journal of Heat and Mass Transfer, 2017, 107: 213-224.

DOI：10.1016/j.ijheatmasstransfer.2016.11.040

• Adsorption
• Activated carbon
• Dynamic model
• Heat transfer
• Mass transfer
• Sorption compressor

Sorption-based cooler is considered as an excellent candidate for the vibration-free cooling at cryogenic temperature. In a such cooler, the sorption compressor is the most critical module. To design a sorption compressor, effective numerical models are essential which allow one to simulate the details of the heat and mass transfer within the sorption-compressor cell, predict the system performance and optimize various parameters. This paper presents a 1-dimensional dynamic model for a sorption-compressor cell, which is based on extensive adsorption-isotherm measurements and realistic thermal properties of materials at low temperatures. This numerical model combines the mass and energy equations while the momentum equation is skipped. It assumes the pressure to be uniform within the cell. However, the convection term in the energy equation is evaluated in this model with proper approximation without calculating the velocity field. A typical simulation case is presented to understand the details during a sorption compression that occur in the sorption-compressor cell. Experiments based on helium and neon operating at 77 K (liquid nitrogen temperature) were carried out to validate this model. The measured compressor performance was deviated from the simulation about 18%, but that is a reasonable inaccuracy for design propose and is well reasoned. Such 1-D dynamic model is qualified to be further used to design sorption compressor.

• 出版日期2017-4
• 单位浙江大学