Microstructure and Corrosion Characterization of Squeeze Cast AM50 Magnesium Alloys

作者：Sachdeva Deepika^*; Tiwari Shashank; Sundarraj Suresh; Luo Alan A

来源：Metallurgical and Materials Transactions B-Process Metallurgy and Materials Processing Science, 2010, 41(6): 1375-1383.

DOI：10.1007/s11663-010-9433-x

Squeeze casting of magnesium alloys potentially can be used in lightweight chassis components such as control arms and knuckles. This study documents the microstructural analysis and corrosion behavior of AM50 alloys squeeze cast at different pressures between 40 and 120 MPa and compares them with high-pressure die cast (HPDC) AM50 alloy castings and an AM50 squeeze cast prototype control arm. Although the corrosion rates of the squeeze cast samples are slightly higher than those observed for the HPDC AM50 alloy, the former does produce virtually porosity-free castings that are required for structural applications like control arms and wheels. This outcome is extremely encouraging as it provides an opportunity for additional alloy and process development by squeeze casting that has remained relatively unexplored for magnesium alloys compared with aluminum. Among the microstructural parameters analyzed, it seems that the beta-phase interfacial area, indicating a greater degree of beta network, leads to a lower corrosion rate. Weight loss was the better method for determining corrosion behavior in these alloys that contain a large fraction of second phase, which can cause perturbations to an overall uniform surface corrosion behavior.

• 出版日期2010-12