科研之友
微信
新浪微博
Facebook
分享链接
摘要
Metal oxide based gas sensors are usually read-out by measuring the overall resistivity of the gas sensitive layer. However, the reaction of the gas species with the metal oxide surface does not only change the electrical conductivity but also effects the required heating power to maintain the layer's temperature. This change in power consumption may be disregarded when using standard bulk sensor chips due to their overall high thermal mass. Nevertheless, micromachined Si based hotplate devices offer the possibility to measure these effects. Here we present results that have been obtained by using a novel hotplate platform optimized for low power consumption and inkjet printing of nano sized gas sensitive metal oxide particles. The temperature of the gas sensitive layer is controlled via the heater resistance and the power consumption is recorded with a fully automated gas measurement system. To separate changes in the heat conductivity of the gas matrix from the heat of the surface reaction, the measurements have been performed in parallel using hotplates with and without a metal oxide layer deposited onto them. Here layers composed of copper (II) oxide have been used to highlight the possibilities of the novel approach. Determining both, the gas dependent resistivity as well as heating power yields two independent sensing quantities from one single device and might be an important cornerstone on the way towards selective metal oxide based gas sensors.
- 出版日期2016-7
