Development of adsorbents from used tire rubber Their use in the adsorption of organic and inorganic solutes in aqueous solution

作者：Troca Torrado Cesar; Alexandre Franco Maria; Fernandez Gonzalez Carmen; Alfaro Dominguez Manuel; Gomez Serrano Vicente^*

来源：Fuel Processing Technology, 2011, 92(2): 206-212.

DOI：10.1016/j.fuproc.2010.03.007

• Used tire rubber
• Carbonaceous adsorbents
• Phenolic compounds
• Metallic ions
• Adsorption

Using used tire rubber (UTR), carbonaceous adsorbents (CAs) were prepared by chemical treatment of the material with HCI, HNO(3) and NaOH aqueous solutions and by heat treatment at 900 degrees C for 2 h in N(2) atmosphere (H900). UTR and the UTR-derived products were first characterized in terms of texture by N(2) adsorption at - 196 degrees C and of oxygen surface groups by FT-IR spectroscopy and pH of the point of zero charge (pH(pzc)). Then, the products were tested as adsorbents of phenol, p-aminophenol, p-nitrophenol, and p-chlorophenol and of chromium, cadmium, mercury and lead in aqueous solution. The development of porosity is very poor in UTR and in the chemically treated products. H900 is the only CA with a better developed porosity, mainly in the regions of meso and macropores. pH(pzc) is close to 7.0 for most of the CAs. As an exception to the rule, pH(pzc) is 8.4 for H900. For this CA, the adsorption of all the adsorptives is greater. Usually, adsorption kinetics are fast. This is so in particular for p-nitrophenol and p-chlorophenol, on the one side, and for mercury and lead, on the other side. Adsorption is much higher for mercury and lead than for the remaining adsorptives.

• 出版日期2011-2