All solid-state high power microwave source with high repetition frequency

作者：Bragg J W B^*; Sullivan W W III; Mauch D; Neuber A A; Dickens J C

来源：Review of Scientific Instruments, 2013, 84(5): 054703.

DOI：10.1063/1.4804196

An all solid-state, megawatt-class high power microwave system featuring a silicon carbide (SiC) photoconductive semiconductor switch (PCSS) and a ferrimagnetic-based, coaxial nonlinear transmission line (NLTL) is presented. A 1.62 cm(2), 50 kV 4H-SiC PCSS is hard-switched to produce electrical pulses with 7 ns full width-half max (FWHM) pulse widths at 2 ns risetimes in single shot and burst-mode operation. The PCSS resistance drops to sub-ohm when illuminated with approximately 3 mJ of laser energy at 355 nm (tripled Nd:YAG) in a single pulse. Utilizing a fiber optic based optical delivery system, a laser pulse train of four 7 ns (FWHM) signals was generated at 65 MHz repetition frequency. The resulting electrical pulse train from the PCSS closely follows the optical input and is utilized to feed the NLTL generating microwave pulses with a base microwave-frequency of about 2.1 GHz at 65 MHz pulse repetition frequency (prf). Under typical experimental conditions, the NLTL produces sharpened output risetimes of 120 ps and microwave oscillations at 2-4 GHz that are generated due to damped gyromagnetic precession of the ferrimagnetic material%26apos;s axially pre-biased magnetic moments. The complete system is discussed in detail with its output matched into 50 Omega, and results covering MHz-prf in burst-mode operation as well as frequency agility in single shot operation are discussed.

• 出版日期2013-5