Mechanical properties and degree of conversion of etch-and-rinse and self-etch adhesive systems cured by a quartz tungsten halogen lamp and a light-emitting diode

作者：Gaglianone Livia Aguilera^*; Lima Adriano Fonseca; Goncalves Luciano Souza; Cavalcanti Andrea Nobrega; Baggio Aguiar Flavio Henrique; Marchi Giselle Maria

来源：Journal of the Mechanical Behavior of Biomedical Materials, 2012, 12: 139-143.

DOI：10.1016/j.jmbbm.2012.01.018

• Adhesive systems
• Polymerization
• Light-curing unit
• Degree of conversion
• Mechanical properties

The aim of the present study was to evaluate the degree of conversion (DC), elastic modulus (E), and flexural strength (FS) of five adhesive systems (only the bonding component of both Scotchbond MP-SBMP and Clearfil Protect Bond-CP; Single Bond 2-SB2; One-up Bond F Plus-OUP; and P90 System Adhesive: primer-P90P and bond-P90B) cured with a quartz tungsten halogen (QTH) lamp and a light-emitting diode (LED). Two groups per adhesive were formed (n = 5), according to the light source (quartz tungsten halogen - QTH: Demetron LC; and light-emitting diode - LED: UltraLume 5). Bar-shaped specimens were evaluated using three-point bending. The DC was obtained by Fourier transform infrared spectroscopy (FTIR). SB2 and P90P exhibited better DC values for QTH curing. However, SB2 and P90P presented the worst results overall. The light source was statistically significant for all adhesives, except for P90B and OUP. Non-solvated adhesives presented the best E and FS values. It could be concluded that the DC and E values can be influenced by the light source; however, this interference is material dependent.

• 出版日期2012-8