科研之友
微信
新浪微博
Facebook
分享链接
摘要
To improve the electrical properties of an 8 mol% yttria-stabilized zirconia (8YSZ) electrolyte, nanocrystalline (10-100 nm) 8YSZ powders were synthesized via a hydrothermal method followed by heat treatment at temperatures ranging from 800 degrees C to 1200 degrees C. Note that all the powders maintained the single-cubic phase structure, as observed via the results of the XRD and Raman spectra. Moreover, the annealing procedure of the powders caused the yttrium concentration of the surface to slightly increase, as observed via X-ray photoelectron spectroscopy (XPS). Moreover, according to the morphology shown in the SEM images and the electrochemical impedance spectroscopy (EIS), the powder grain size had an effect on the microstructure of the electrolytes fabricated via the conventional sintering method. In addition, it further influenced the relative density and conductivity of the electrolytes, which both first increased and then decreased with the increase in the powder grain size in the range of 10-100 nm. This showed that the powders with 50-80 nm grain size exhibited the best performance since it was not easy to induce grain coarsening in ceramics. The electrolyte sintered by these powders showed uniform and hexagonal grains with a mean size of 0.97 mm and a relative density of over 99%. Because of a large sum of grain boundaries and point defects, the electrolyte had a good conductivity of 174.1 mS cm(-1) at 1000 degrees C measured by the four-probe DC method. In addition, the activation energy (0.955 eV) is lower than that for other samples; this suggests that 8 mol% Y2O3-stabilized ZrO2 has more advantages at lower working temperatures for SOFCs.
- 出版日期2017
- 单位北京有色金属研究总院
