科研之友
微信
新浪微博
Facebook
分享链接
摘要
Welding introduces significant residual stresses in the welded structure/component due to non-uniform heat distribution during heating and cooling cycle. To control, reduce, or beneficially redistribute the residual stresses in weld joints, the stress distribution needs to be known. In the present study, weld joints of 10 mm thick 316LN stainless steel were made by multi-pass TIG and A-TIG welding processes and their residual stresses distribution and distortion values were measured and compared. While V-groove edge preparation was required for making multi-pass TIG weld joint, square-edge preparation was sufficient for making single pass A-TIG weld joint. Ultrasonic nondestructive technique based on the critically refracted longitudinal waves (LCR waves) has been used for the quantitative surface/sub-surface residual stress measurements in the weld joints. Distortion measurements were carried out before and after welding using height gauge. Peak tensile residual stress and the angular distortion values were lower in the A-TIG weld joint compared to that of the multipass TIG weld joint.
- 出版日期2012
