Aqueous Processing of Low-Band-Gap Polymer Solar Cells Using Roll-to-Roll Methods

作者：Andersen Thomas R; Larsen Olsen Thue T; Andreasen Birgitta; Bottiger Arvid P L; Carle Jon E; Helgesen Martin; Bundgaard Eva; Norrman Kion; Andreasen Jens W; Jorgensen Mikkel; Krebs Frederik C^*

来源：ACS Nano, 2011, 5(5): 4188-4196.

DOI：10.1021/nn200933r

• roll-to-roll coating polymer solar cells
• organic solar cells
• slot-die coating
• aqueous inks
• nanoparticle dispersions

Aqueous nanoparticle dispersions of a series of three low-band-gap polymers poly[4,8-bis(2-ethyihexyloxy)benzo(1,2-b:4,5-b')dithiophene-alt-5,6-bis(octyloxy)-4,7-di(thiophen-2-yl)(2,1,3-benzothiadiazole)-5,5'-dlyl] (P1), poly[(4,4'-bis(2-ethylhexyl)dithieno[3,2-b:2',3'-d]silole)-2,6-diyl-alt-(2,1,3-benzothiadiazole)-4,7-diyl] (P2), and poly[2,3-bis-(3-octyloxyphenyflquinoxaline-5,8-dlyl-alt-thlophene-2,5-dly1) (P3) were prepared using ultrasonic treatment of a chloroform solution of the polymer and [6,6]-phenyl-C-61-butyric acid methyl ester ([60]PCBM) mixed with an aqueous solution of sodium dodecylsulphate (SDS). The size of the nanoparticles was established using small-angle X-ray scattering (SAXS) of the aqueous dispersions and by both atomic force microscopy (AFM) and using both grazing incidence SAXS (GISAXS) and grazing incidence wide-angle X-ray scattering (GIWAXS) in the solid state as coated films. The aqueous dispersions were dialyzed to remove excess detergent and concentrated to a solid content of approximately 60 mg mL(-1). The formation of films for solar cells using the aqueous dispersion required the addition of the nonionic detergent FS0-100 at a concentration of 5 mg mL(-1).This enabled slot-die coating of high quality films with a dry thickness of 126 +/- 19, 500 +/- 25, and 612 +/- 22 nm P1, P2, and P3, respectively for polymer solar cells. Large area inverted polymer solar cells were thus prepared based on the aqueous inks. The power conversion efficiency (PCE) reached for each of the materials was 0.07, 0.55, and 0.15% for P1, P2, and P3, respectively. The devices were prepared using coating and printing of all layers including the metal back electrodes. All steps were carried out using roll-to-roll (R2R) slot-die and screen printing methods on flexible substrates. All five layers wens processed using environmentally friendly methods and solvents. Two of the layers were processed entirely from water (the electron transport layer and the active layer).

• 出版日期2011-5