科研之友
微信
新浪微博
Facebook
分享链接
摘要
Continuous positive airway pressure (CPAP) devices are popularly used for obstructive sleep apnoea (OSA) treatment. However, the noise level emission from these devices has been identified as a potential factor for patient's discomfort and rejection. There is a need to obtain information on the noise characteristics and source locations in order to tackle the most serious noise source within these devices. A typical CPAP device was used for the investigation and its sound characteristics and sound power levels were determined. The noise generated from a centrifugal fan was also independently investigated to address its contribution to the overall noise of the device. Frequency analysis suggested that the noise generated from both the CPAP device and the fan is broadband in nature with discrete peaks containing rotational and non-rotational components. The broadband components were then studied in detail using numerical simulation approach. Computational aeroacoustics (CAA) method with hybrid approach was used to a three-dimensional (3-D) CPAP fluid model to predict the aerodynamic and aeroacoustics behaviours of the device. This showed a complicated flow structure involving flow separation, rotation, and vortices in several locations which resulted in high level of flow turbulence inside the device. The turbulent components were used to estimate the broadband noise level at source using the broadband noise source (BNS) models. It shows the most critical location is at the fan region and at the fan inlet.
- 出版日期2016-12-15
