Microstructural and phase transformations during sintering of a phillipsite rich zeolitic tuff

作者：Ergul Sibel; Sappa Giuseppe^*; Magaldi Donatello; Pisciella Paola; Pelino Mario

来源：Ceramics International, 2011, 37(6): 1843-1850.

DOI：10.1016/j.ceramint.2011.03.048

• Zeolitic tuff
• sintering process
• thermal behaviour
• microstructural and phase transformations

Microstructural and phase transformations during sintering of a Phillipsite rich zeolitic tuff, from Tenerife, Canary Islands, was investigated in order to their utilization in ceramic manufacturing industries. Green samples were obtained from powders and pressed at 150 MPa and heat-treated for 1 hour in the temperature range between 900-1080 degrees C. The zeolitic tuffs show endothermic peaks at about 100 degrees C and 200 degrees C, corresponding to dehydration of zeolitic water observed in the thermo- gravimetric curves and at similar to 700 degrees C a small endothermic peak was identified corresponding to the structural breakdown of Phillipsite. According to the dilatometric traces, at about 870 degrees C, sintering of solid particles starts and a linear shrinkage of about 6% is reached at about 1050 degrees C. The maximum absolute and apparent densities were obtained after sintering at 1040 degrees C (absolute density = 2.59 g/cm(3); apparent density = 2.33 g/cm(3)). Over this temperature, the sample heat-treated at 1060 degrees C, density results show a decreasing trend. The chemical composition of studied zeolitic tuffs make possible the liquid phase formation during heat-treatment, through the supplement of alkaline oxides. SEM image of the sample obtained at 1040 degrees C shows a zone with micro-crystallinity around the boundary of Sanidine grain highlighting the beginning of the phase transition from Sanidine, to Microcline. Heat-treatment effect of zeolitic tuff leads to the decomposition of Phillipsite and Sanidine and the formation of a new crystal phase of Hematite.

• 出版日期2011-8