A new method for calculation of water saturation in shale gas reservoirs using V-P-to-V-S ratio and porosity

作者：Liu, Kun; Sun, Jianmeng^*; Zhang, Hongpan; Liu, Haitao; Chen, Xiangyang

来源：Journal of Geophysics and Engineering, 2018, 15(1): 224-233.

DOI：10.1088/1742-2140/aa83e5

• total water saturation
• V-P-to-V-S ratio
• viscoelastic BISQ model
• shale gas reservoirs

Total water saturation is an important parameter for calculating the free gas content of shale gas reservoirs. Owing to the limitations of the Archie formula and its extended solutions in zones rich in organic or conductive minerals, a new method was proposed to estimate total water saturation according to the relationship between total water saturation, V-P-to-V-S ratio and total porosity. Firstly, the ranges of the relevant parameters in the viscoelastic BISQ model in shale gas reservoirs were estimated. Then, the effects of relevant parameters on the V-P-to-V-S ratio were simulated based on the partially saturated viscoelastic BISQ model. These parameters were total water saturation, total porosity, permeability, characteristic squirt-flow length, fluid viscosity and sonic frequency. The simulation results showed that the main factors influencing V-P-to-V-S ratio were total porosity and total water saturation. When the permeability and the characteristic squirt-flow length changed slightly for a particular shale gas reservoir, their influences could be neglected. Then an empirical equation for total water saturation with respect to total porosity and V-P-to-V-S ratio was obtained according to the experimental data. Finally, the new method was successfully applied to estimate total water saturation in a sequence formation of shale gas reservoirs. Practical applications have shown good agreement with the results calculated by the Archie model.

• 出版日期2018-2
• 单位中国石油大学（华东）