科研之友
微信
新浪微博
Facebook
分享链接
摘要
The penetration and perforation of a polymethylmethacrylate (PMMA) plate is investigated experimentally and numerically. Two combined failure criteria are used in the numerical analyses: ductile failure with damage evolution and tensile failure. The measured mechanical properties of PMMA are input to the analysis. The determination of the damage evolution parameter in this material is calibrated by simulating and replicating shear localization results obtained in confined PMMA cylinders. The numerical simulation based on these parameters is tested by comparing the numerical trajectory prediction to actual trajectories of inclined impacts of projectiles. The first comparison is qualitative and shows that the numerical simulation predicts ricochet of a projectile impacting at an angle of inclination 30 as reported by Rosenberg et al. (2005) [1]. Additional successful comparison with experimental results of inclined impact of a 0.5 '' AP projectile on 3 PMMA plates is reported. The contribution of each failure criterion to the projectile trajectory is studied, showing that the ductile failure criterion enforces a straight trajectory in the initial velocity direction while the tensile failure criterion controls the deflection and ricochet phenomenon. The numerical analyses are further used to study the effect of the angle of inclination on the trajectory and kinetic energy of the projectile. The effect of the projectile mass and impact velocity on the depth of penetration (DOP) was investigated too. It is found that the ricochet phenomenon happens for angles of inclination of 0 degrees < alpha <= 30 degrees. The projectile perforates the plate for 50 degrees <= alpha <= 90 degrees, thus defining a failure envelope for this experimental configuration. For normal impact (alpha = 90 degrees) the DOP scales linearly with the projectile's mass and can be fitted by a square polynomial with the impact velocity.
- 出版日期2010-3
