Low temperature sintering of binder-containing TiO2/metal peroxide pastes for dye-sensitized solar cells

作者：Holliman Peter J^*; Muslem Dhiyaa K; Jones Eurig W; Connell Arthur; Davies Matthew L; Charbonneau Cecile; Carnie Matthew J; Worsley David A

来源：Journal of Materials Chemistry A, 2014, 2(29): 11134-11143.

DOI：10.1039/c4ta01000k

Nano-structured metal oxide films are key components of dye-sensitized (DSC) solar cells. Scaling such devices requires lower temperature processing to enable cheaper substrates to be used. In this context, we report a new and scalable method to sinter binder-containing metal oxide pastes to make DSC photo-electrodes at lower temperatures. Metal peroxide powders (CaO2, MgO2, or ZnO2) were added to terpineol-based P25 pastes containing ethyl cellulose binder or to commercial TiO2 paste (DSL18NR-T). Thermal analysis shows that binder decomposition occurs at 300 degrees C instead of the standard 450 degrees C for a TiO2-only paste and suggests that the metal peroxides act as combustion promoters releasing heat and oxygen within the film while heating. The data show that this heat and oxygen release coincide best with binder combustion for ZnO2 and DSC device tests show that adding ZnO2 to TiO2 pastes produces the best performances affording eta = 7.5% for small devices (0.26 cm(2)) and eta = 5.7% at 300 degrees C or 450 degrees C for DSL18NR-T/ZnO2 for larger (1 cm(2)) devices. To the best of our knowledge, the performance of the (0.26 cm(2)) cells is comparable to the highest efficiency devices reported for DSCs fabricated using low temperature methods. The device efficiency is most strongly linked with J(sc); BET and dye sorption measurements suggest that J(sc) is linked with the metal oxide surface area and dye loading. The latter is linked to the availability of surface sorption sites for dye molecules which is strongly negatively affected by any residual organic binder which resulted from incomplete combustion.

• 出版日期2014