Dependency on Runner Geometry for Reversible-Pump Turbine Characteristics in Turbine Mode of Operation

作者：Olimstad Grunde^*; Nielsen Torbjorn; Borresen Bjarne

来源：Journal of Fluids Engineering-Transactions of the ASME, 2012, 134(12): 121102.

DOI：10.1115/1.4007897

• reversible-pump turbines
• stability
• characteristics
• geometry
• inlet profile
• measurement
• numerical simulation

Characteristics of a reversible-pump turbine have been measured with five different leading edge profiles in turbine mode. These profiles varied the inlet blade angle and the radius of curvature. Further geometry parameters have been investigated through numerical simulations. The pump turbine tested has much steeper flow-speed characteristics than a comparable Francis turbine. The most obvious geometry difference is the inlet part of the runner blades, where the blade angle for the pump turbine is much smaller than for the Francis turbine. Two different blade angles have been tested on a physical model and computational fluid dynamics (CFD) simulations have been performed on four different angles. Both methods show that a smaller blade angle gives less steep characteristics in turbine mode, whereas the measured s-shape in turbine brake- and turbine pumping mode gets more exaggerated. Long-radius leading edges result in less steep characteristics. The unstable pump turbine characteristics are in the literature shown to be a result of vortex formation in the runner and guide vane channels. A leading edge with longer curvature radius moves the formation of vortices towards higher speed of rotation. [DOI: 10.1115/1.4007897]

• 出版日期2012-12