A determination method of compressive design value of dimensional lumber

作者：Zhong, Yong^*; Wu, Guofang; Ren, Haiqing; Jiang, Zehui

来源：Journal of Wood Science, 2018, 64(5): 526-537.

DOI：10.1007/s10086-018-1737-5

• Compressive design value
• Dimensional lumber
• Full size
• Reliability analysis

The objective of this study was to develop a determination method of compressive design value of dimensional lumber for its safety design and rational application as a green building material. A total of 1049 full-size 2x4 samples of Chinese larch (Larix gmelinii) dimensional lumber, including visual grades Ic, IIc, IIIc, and IVc, were tested by static compressive tests. Compression strength parallel to grain (UCS) of different grades were summarized. By the least square method, the fitted parameters and results for UCS were obtained under different probability distribution models (normal, lognormal and 2-P-Weibull) and test data points (100, 75, 50, 25, and 15%). Based on reliability analysis method, relationships between the reliability index and partial factor were investigated under different probability distribution models, fitting data points, load combinations and load ratios. Finally, this study suggested that the lognormal distribution, 25% data points, load combination of dead load plus residential live load, and load ratio of 1.0 be selected for the determination of compressive design value of Chinese larch dimensional lumber. For Chinese larch dimensional lumber, the compressive design values of grade Ic, IIc, IIIc and IVc were 22.9, 18.3, 14.6 and 13.8MPa, respectively.

• 出版日期2018-10
• 单位中国林业科学研究院; 国际竹藤中心; 中国林业科学研究院林业研究所