科研之友
微信
新浪微博
Facebook
分享链接
摘要
The reduction shaft furnace is a countercurrent moving bed cylindrical reactor in which hematite pellets are reduced by a gas mixture of H-2 and CO. Most of the reduction shaft furnaces use hydrogen rich gas as reducing gas. The materials and heat balances show that the heat balance determines the gas consumption. Compared with the gas requirement by reduction reaction, a much greater quantity of gas has to be blown into the furnace to satisfy the heat balance, leading to a high energy consumption and high excess of reduction potential of top gas. To solve this problem, a new approach is proposed where some oxygen is blown into the upper zone of the shaft furnace. As the feasibility study of such an approach, a static model was developed first to calculate input gas flowrate and oxygen rate. Then, based on conservations of mass and heat, a kinetic model for a typical MIDREX shaft furnace was developed to investigate the proper position for oxygen blowing. The model predictions were validated by comparison with production data. Finally, a kinetic model was developed to investigate the process of shaft furnace with oxygen blowing. The results show that the gas consumption can be reduced from 1897 to 1405 N m(3) tDRI(-1) with oxygen blowing of 20.3 N m(3) tDRI(-1). After oxygen blowing, the temperature increases sharply, the concentration of CO and H-2 decreases, and reduction potential of top gas decreases from 1.48 to 0.69, showing that the gas utilisation is greatly improved. These models can be used for process optimisation development.
- 出版日期2014-9
- 单位东北大学
