Hybrid micro electrostatic actuator

作者：Hailu Zewdu; He Siyuan^*; Ben Mrad Ridha

来源：Microsystem Technologies, 2016, 22(2): 319-327.

DOI：10.1007/s00542-015-2424-8

A hybrid micro-electrostatic actuator is presented. The actuator integrates a vertical comb driving (VCD) unit and a parallel-plate driving (PPD) unit. The hybrid actuator is fabricated using a one structural layer microfabrication process, i.e., MetalMUMPs instead of a two-layer microfabrication process needed for traditional vertical comb-drive actuators by taking advantage of the residual stress gradient in the MetalMUMPs nickel layer, which raises the moving parts of the actuator above the substrate after release. The hybrid actuator significantly simplifies the fabrication process for vertical comb-drive actuators, i.e., turning a process requiring two structural layers into a process requiring only one structural layer and thus avoids any misalignment between the two layers. The hybrid actuator can generate larger force and then a larger displacement than the actuator having only the VCD with the same area since no extra space is needed for the PPD unit which uses the moving electrode existing in the VCD unit and a fixed electrode under the VCD unit. The VCD and PPD units in the hybrid actuator are subject to the same driving voltage and work together to pull the moving parts of the actuator downward. A model is established for the hybrid actuator to analyze its displacement. The analytical results show that displacement of the moving part of the hybrid actuator is about half of the gap between the electrodes of the PPD unit. Prototypes are fabricated and tested. With a driving voltage of 150 V, the hybrid actuator achieved a measured displacement of 6.48 A mu m.

• 出版日期2016-2