An oxidation-resistant indium tin oxide catalyst support for proton exchange membrane fuel cells

作者：Chhina H^*; Campbell S; Kesler O

来源：Journal of Power Sources, 2006, 161(2): 893-900.

DOI：10.1016/j.jpowsour.2006.05.014

• catalyst support
• oxidation
• indium tin oxide
• ebonex
• carbon
• proton exchange membrane fuel cells

The oxidation of carbon catalyst supports causes degradation in catalyst performance in proton exchange membrane fuel cells (PEMFCs). Indium tin oxide (ITO) is considered as a candidate for an alternative catalyst support. The electrochemical stability of ITO was studied by use of a rotating disk electrode (RDE). Oxidation cycles between +0.6 and +1.8 V were applied to ITO supporting a Pt catalyst. Cyclic voltammograms (CVs) both before and after the oxidation cycles were obtained for Pt on ITO, Hispec 4000 (a commercially available catalyst), and 40 wt.% Pt dispersed in-house on Vulcan XC-72R. Pt on ITO showed significantly better electrochemical stability, as determined by the relative change in electrochemically active surface area after cycling. Hydrogen desorption peaks in the CVs existed even after 100 cycles from 0.6 to 1.8 V for Pt on ITO. On the other hand, most of the active surface area was lost after 100 cycles of the Hispec 4000 catalyst. The 40 wt.% Pt on Vulcan made in-house also lost most of its active area after only 50 cycles. Pt on ITO was significantly more electrochemically stable than both Hispec 4000 and Pt on Vulcan XC-72R. In this study, it was found that the Pt on ITO had average crystallite sizes of 13 nm for Pt and 38 nm for ITO. Pt on ITO showed extremely high thermal stability, with only similar to 1 wt.% loss of material for ITO versus similar to 57 wt.% for Hispec 4000 on heating to 1000 degrees C. The TEM data show Pt clusters dispersed on small crystalline ITO particles. The SEM data show octahedral shaped ITO particles supporting Pt.

• 出版日期2006-10-27