Application of copper sulfate pentahydrate as an ammonia removal reagent for the determination of trace impurities in ammonia by gas chromatography

作者：Aomura Yoko^*; Kobayashi Yoshihiko; Miyazawa Yuzuru; Shimizu Hideharu

来源：Journal of Chromatography A, 2010, 1217(11): 1838-1844.

DOI：10.1016/j.chroma.2010.01.039

• Gas chromatography
• Gas analysis
• Ammonia
• Copper sulfate pentahydrate

Rapid analysis of trace permanent gas impurities in high purity ammonia gas for the microelectronics industry is described. using a gas chromatograph equipped with a phtoionization detector Our system incorporates a reactive precolumn in combination with the analytical column to remove the ammonia matrix peak that otherwise would complicate the measurements due to baseline fluctuations and loss of analytes The performance of 21 precolumn candidate materials was evaluated Copper sulfate pentahydrate (CuSO(4) 5H(2)O) Was shown to selectively react with ammonia at room temperature and atmospheric column pressures, without affecting the hydrogen, oxygen, nitrogen, methane or carbon monoxide peak areas To prevent loss of trace carbon dioxide, an additional boron trioxide reactant layer was inserted,above the copper sulfate pentahydrate bed in the reactive precolumn Using the combined materials, calibration curves for carbon dioxide proved to be equivalent in both ammonia and helium matrix gases These curves were equivalent in both matrix gases. The quantitative performance of the system was also evaluated Peak repeatabilities, based on eight injections, were in the range of 4 1-8 2% relative standard deviation, and detection limits were 6 9 ppb for H(2), 1 8 ppb for O(2), 1 6 ppb for N(2), 6 4 ppb for CH(4), 13 ppb for CO, and 5 4 ppb for CO(2).

• 出版日期2010-3-12