Deposition of coal ash on a vertical surface in a 100 kW downflow laboratory combustor: A comparison of theory and experiment

作者：Zhan Zhonghua^*; Fry Andrew R; Wendt Jost O L

来源：Proceedings of the Combustion Institute, 2017, 36(2): 2091-2101.

DOI：10.1016/j.proci.2016.05.011

• Deposition
• Vertical surface
• Thermophoresis
• Theory and experiment

This paper is concerned with deposition rates of coal ash on a vertical surface in a 100 kW rated down-flow laboratory coal combustor. At that scale, flow in the post flame where deposition occurs, is laminar, and the deposits on a vertical surface are similar to the early, sticky, inner deposits on horizontal surfaces. Therefore the problem addressed has relevance to understanding mechanisms of deposit formation in general. Experimental data presented here consist of particle size distributions of the ash aerosol, and time resolved measurements of the vertical deposit mass, for various controlled surface temperatures, one coal, and two combustion conditions: air-firing and oxy-firing with 50% inlet O-2. Theory consisted of a transport model in which the criterion on whether an ash particle was captured, depended on a newly introduced "Thermophoresis Number", Tp, which is the ratio of the time taken for the particle to contact the (cold) surface through thermophoresis, to that for the particle to pass by the surface. If Tp <1 the particle is captured; otherwise it escapes. It is assumed that only those particles in the sub-micron vaporization mode are both subject to thermophoresis and will stick to the surface. Using calculated velocity and temperature fields in the fluid nensional cross-sectional area that defined the area through which all particles that will con-tacext to the vertical surface, and the Tp <1 criterion alluded to above, it was possible to calcu-late a two-dimt the vertical surface must pass. Ash deposition rates so calculated were compared to experimental data. Quantitative agreement between theory and experiment was fair, considering the difficulties in accurately measuring deposition rates and in view of simplifications contained in the model.

• 出版日期2017