Angled-predrilling depth and mini-implant shape effects on the mechanical properties of self-drilling orthodontic mini-implants during the angled insertion procedure

作者：Heo Yoon Young; Cho Keun Chul; Baek Seung Hak^*

来源：The Angle Orthodontist, 2012, 82(5): 881-888.

DOI：10.2319/100711-629.1

• Mechanical properties
• Orthodontic mini-implants
• Angled-predrilling depth
• Mini-implant shape
• Angled insertion

Objective: To investigate the effects of orthodontic mini-implant (OMI) shape and angled-predrilling depth on the mechanical properties of OMIs during the angled insertion procedure.
Materials and Methods: A total of 30 OMIs (self-drilling type, 7 mm in length) were allocated into six groups according to the OMI shape (cylindrical or tapered) and angled-predrilling depth (control, 1.5-mm and 4.0-mm angled-predrilling; predrilled with 1-mm diameter drill-bit), as follows: C-con, C-1.5, C-4.0, T-con, T-1.5, and T-4.0 groups (N = 5 per group). The OMIs were installed at an angle of 60 degrees in double-layer artificial bone blocks that simulated the cortical and cancellous bone (Sawbone (R)). Total insertion time (TIT), maximum insertion torque (MIT), total insertion energy (TIE), and inclination of the time-torque graph (INC) were measured.
Results: Within the same shape group, angled-predrilling had a shorter TIT than did the control (control vs 1.5; control vs 4.0; all P < .05). MIT and TIE decreased in the order of control, 1.5-mm, and 4.0-mm angled-predrilling (control vs 1.5; 1.5 vs 4.0; all P < .05), but INC increased from control to 1.5-mm angled-predrilling and decreased from 1.5-mm to 4.0-mm angled-predrilling within the same shape group (control vs 1.5, 1.5 vs 4.0; all P <.05). The MIT of the tapered group was greater than that of the cylindrical group (C-con vs T-con, C-1.5 vs T-1.5; all P <.05, C-4.0 vs T-4.0; P < .01). In the same angled-predrilling depth, no differences were observed in TIE between the cylindrical and tapered groups (C-1.5 vs T-1.5, C-4.0 vs T-4.0; all P > .05).
Conclusions: In angled-predrilling insertion of OMIs into thick cortical bone, tapered OMIs might be a better choice than cylindrical OMIs for increasing primary stability because of higher MIT and similar TIE values. (Angle Orthod. 2012;82:881-888.)

• 出版日期2012-9