Anisotropic interfacial tension, contact angles, and line tensions: A graphics-processing-unit-based Monte Carlo study of the Ising model

作者：Block Benjamin J^*; Kim Suam; Virnau Peter; Binder Kurt

来源：Physical Review E, 2014, 90(6): 062106.

DOI：10.1103/PhysRevE.90.062106

As a generic example for crystals where the crystal-fluid interface tension depends on the orientation of the interface relative to the crystal lattice axes, the nearest-neighbor Ising model on the simple cubic lattice is studied over a wide temperature range, both above and below the roughening transition temperature. Using a thin-film geometry L-x x L-y x L-z with periodic boundary conditions along the z axis and two free L-x x L-y surfaces at which opposing surface fields +/- H-1 act, under conditions of partial wetting, a single planar interface inclined under a contact angle theta %26lt; pi/2 relative to the yz plane is stabilized. In the y direction, a generalization of the antiperiodic boundary condition is used that maintains the translational invariance in the y direction despite the inhomogeneity of the magnetization distribution in this system. This geometry allows a simultaneous study of the angle-dependent interface tension, the contact angle, and the line tension (which depends on the contact angle, and on temperature). All these quantities are extracted from suitable thermodynamic integration procedures. In order to keep finite-size effects as well as statistical errors small enough, rather large lattice sizes (of the order of 46 million sites) were found to be necessary, and the availability of very efficient code implementation of graphics processing units was crucial for the feasibility of this study.

• 出版日期2014-12-1