Highly porous PVDF hollow fiber membranes for VMD application by applying a simultaneous co-extrusion spinning process

作者：Zhao, Lihua; Wu, Chunrui^*; Liu, Zhiyu; Zhang, Qinglei; Lu, Xiaolong^*

来源：Journal of Membrane Science, 2016, 505: 82-91.

DOI：10.1016/j.memsci.2016.01.014

• Polyvinylidene fluoride
• Simultaneous co-extrusion spinning process
• Surface porosity
• Flux improvement
• Membrane distillation

Highly porous polyvinylidene fluoride (PVDF) hollow fiber membranes are of great interest for membrane contactor applications such as sea water desalination by membrane distillation in order to enhance the flux of the process. For the first time in this paper, porous hydrophobic PVDF asymmetric hollow fiber membranes with a high outer surface porosity for use in vacuum membrane distillation (VMD) were successfully fabricated by applying a simultaneous co-extrusion spinning process through the non-solvent induced phase separation (NIPS) method. In this approach, five kinds of dual-layer composite membranes were prepared by employing different inner and outer polymer dopes. Single-layer membrane was also fabricated through the conventional dry-jet wet phase inversion method. Results revealed that the introduction of the simultaneous co-extrusion spinning process greatly increased the outer surface porosity of the dual-layer composite membranes. It was also observed that the VMD flux of the dual-layer membranes spun through the simultaneous co-extrusion spinning process was 54% higher than the single-layer membrane fabricated by the conventional dry-jet wet phase inversion method. A VMD flux as high as 61.8 kg/(m(2) h) at 70 degrees C was obtained for the novel dual-layer composite membranes.

• 出版日期2016-5-1
• 单位天津工业大学