Analysis of a tip correction factor for horizontal axis turbines

作者：Wimshurst A^*; Willden R H J

来源：Wind Energy, 2017, 20(9): 1515-1528.

DOI：10.1002/we.2106

• tip correction factor
• tip loss
• MEXICO
• actuator line method
• rotor aerodynamics
• CFD

It is imperative to include three-dimensional tip flow corrections when using low-order rotor models that rely on the flow independence principle to compute the blade forces. These corrections aim to account for the effect of pressure equalization at the tips and the accompanying spanwise pressure gradients on the outboard sections, by reducing the computed axial and tangential forces as the blade tips are approached. While Glauert-type corrections are conventionally employed for actuator disc-type computations, alternative corrections are required for actuator line computations as they use a finite blade representation. We present actuator line computations of the Model Rotor Experiments in Controlled Conditions (MEXICO) rotor to investigate tip corrections. Using the tip correction factor proposed by Shen et al. (Wind Energy 2005; 8:457-475), the actuator line computations show an improvement in accuracy over similar computations undertaken without a tip correction factor included. Further improvement to the blade loading is achieved by recalibrating the tip correction factor using data extracted from blade resolved computations of the model rotor experiments in controlled conditions rotor. From the rotor resolved computations, the tip loss (reduction in the blade loading on the outboard sections) is found to be more aggressive in the tangential direction than the axial direction. To account for this, we recalibrate the tip correction factor separately in the axial and tangential directions to develop new directionally dependent tip corrections. The resulting actuator line computations show a further improvement in accuracy of the tangential blade loading, resulting in better prediction of the rotor power.

• 出版日期2017-9