科研之友
微信
新浪微博
Facebook
分享链接
摘要
Aerosol deposition (AD) is a promising method to apply ceramic films on a wide range of substrate materials. Until now, AD has mainly been performed using a single ceramic powder. In this work, mixtures of two different ceramic powders were prepared. The first mixture consisted of Bi2O3 and TiO2 and the second consisted of Bi2O3 and V2O5, in stoichiometric ratios to form Bi4Ti3O12 and Bi4V2O11-, respectively. Aerosol codeposition produced films with homogeneously distributed particle fractions and thicknesses between 10 and 100m. Composite films were annealed to temperatures up to 750 degrees C to enable an in situ calcination and attempted formation of the above-mentioned compounds. Successful formation of Bi4Ti3O12 was tracked by hot-stage X-ray diffraction (XRD), and confirmed by dielectric measurements. Formation of the intended Bi4V2O11-, on the other hand, was not achieved, but rather BiVO4, which was confirmed by XRD, EDX and electrical measurements. The bismuth deficiency occurred during spray deposition, and is attributed to powder/material characteristics. Additional insight about the AD process is gained by comparing mixtures of oxides with different relative hardness values. Aerosol codeposition of ceramics may be an interesting new technique for producing porous functional ceramics.
- 出版日期2015-3
