An electrode-supported fabrication of thin polybenzimidazole membrane-based polymer electrolyte membrane fuel cell

作者：Yuk Seongmin; Lee Dong Hyun; Choi Sungyu; Doo Gisu; Lee Dong Wook; Kim Hee Tak

来源：Electrochimica Acta, 2018, 270: 402-408.

DOI：10.1016/j.electacta.2018.03.052

• High temperature polymer electrolyte membrane fuel cell
• Polybenzimidazole membrane
• Membrane electrode assembly
• Anode supported structure
• Power performance

H3PO4-doped polybenzimidazole (PBI) membranes have been employed for high temperature polymer electrolyte membrane fuel cell (HT-PEMFC). Although a thinner PBI membrane is beneficial in enhancing power performance, the use of thin PBI membrane has been hindered by its poor mechanical property and consequent difficulty in membrane handling during membrane electrode assembly (MEA) fabrication. Here, novel fabrication route to realize a thin PBI membrane (similar to 35 mm)-based HT-MEA is presented. The key feature of the process is to fabricate thin blend membrane of PBI and poly(ethylene glycol) (PEG) and laminate the blend membrane to anode gas diffusion electrode (GDE) followed by H3PO4 doping. The introduction of PEG to PBI film enables the tight bonding of the membrane to the GDE at a mild lamination temperature and mitigates the membrane expansion with the doping, preserving the tight interfacial bonding. Due to the lowered membrane thickness, the corresponding MEA exhibits a high power density of 264 mW cm(-2) at 0.6 V. Therefore, the new fabrication strategy based on the blend of PBI/PEG is highly effective in improving both process and power performance of HT-MEA.

• 出版日期2018-4-20