Advanced Numerical Modeling of Cracked Tubular K Joints: BEM and FEM Comparison

作者：Borges L^*; Chiew S P; Nus**aumer A; Lee C K

来源：Journal of Bridge Engineering, 2012, 17(3): 432-442.

DOI：10.1061/(ASCE)BE.1943-5592.0000274

• Boundary elements
• Finite elements
• Fracture mechanics
• Stress intensity factors
• Welded joints
• Tubular bridges
• K joints

A critical aspect in the design of tubular bridges is the fatigue performance of the structural joints. The estimation of a fatigue crack life using the linear elastic fracture mechanics (LEFM) theory involves the calculation of stress intensity factors (SIF) at a number of discrete crack depths. The most direct way is to carry out modeling by either the finite-element method (FEM) or the boundary-element method (BEM). For tubular joints commonly found in tubular bridges and off-shore structures, due to the complicated geometry resulting from the tube intersections and welding, the construction of the numerical model often becomes a complex process. This paper presents two different model construction techniques that have been developed independently at the Swiss Federal Institute of Technology (EPFL) and the Nanyang Technological University (NTU), Singapore, that are based in the BEM and the FEM, respectively. The SIF values obtained by these two methods are compared. It is found that as long as consistent geometric models are employed, compatible SIF values can be obtained by both approaches. The best and the most consistent values are obtained for the deepest point along the crack front and should be used for fatigue-life computations. DOI: 10.1061/(ASCE)BE.1943-5592.0000274.

• 出版日期2012-6
• 单位南阳理工学院