Direct numerical simulation of a turbulent flow over an axisymmetric hill

作者：Castagna Jony; Yao Yufeng^*; Yao Jun

来源：Computers & Fluids, 2014, 95: 116-126.

DOI：10.1016/j.compfluid.2014.02.014

• Turbulence simulation
• 3D flow separation

Direct numerical simulation (DNS) of a turbulent flow over an axisymmetric hill has been carried out to study the three-dimensional flow separation and reattachment that occur on the lee-side of the geometry. The flow Reynolds number is Re-H = 6500, based on free-stream quantities and hill height (H). A synthetic inflow boundary condition, combined with a data feed-in method, has been used to generate the turbulent boundary layer approaching to the hill. The simulation has been run using a typical DNS resolution of Delta x (-) = 12.5, Delta z(1) = 6.5, and Delta y(1) = 1.0 and about 10 points in the viscous sublayer. It was found that a separation bubble exists at the foot of the wind-side of the hill and the incoming turbulent boundary layer flow undergoes re-laminarization process around the crest of the hill. These lead to a significant flow separation at the lee-side of the hill, where a very large primary separation bubble embedded with a smaller secondary separations have been captured. The present low-Re simulation reveals some flow features that are not observed by high-Re experiments, thus is useful for future experimental studies.

• 出版日期2014-5-22