Al-Mg-Cu based alloys and pure Al processed by high pressure torsion: The influence of alloying additions on strengthening

作者：Zhang Jiuwen^*; Gao Nong; Starink Marco J

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2010, 527(15): 3472-3479.

DOI：10.1016/j.msea.2010.02.016

• Aluminium alloys
• High pressure torsion
• Geometrically necessary dislocations
• Cold work
• Clusters

The influence of alloying additions on strengthening of high pressure torsion (HPT) processed alloys was investigated using commercially pure Al (Al-1050 alloy) and five Al-(1-3)Mg-(0-4)Cu alloys (in wt%). Microhardness was measured on cross-sections. For Al-1050 the microhardness reaches a peak at an effective strain of about three and subsequently decreases. The microhardness of Al-Mg-Cu alloys increases strongly and continuously with increasing equivalent strain. This workhardening rate is enhanced by increasing Mg content over the entire range of strain. Furthermore, the workhardening rates were higher in Cu-free and low Cu-containing (<= 0.4%) Al-Mg alloys as compared to high Cu-containing Al-Mg alloy at strains less than three. The results indicate that dislocation-solute and dislocation-cluster interactions play an important role in strengthening.

• 出版日期2010-6-15
• 单位大连理工大学