Normal and shear forces between a polyelectrolyte brush and a solid surface

作者：Kampf N; Gohy JF; Jerome R; Klein J^*

来源：Journal of Polymer Science Part B: Polymer Physics , 2005, 43(2): 193-204.

DOI：10.1002/polb.20321

• polyelectrolyte brushes
• lubrication
• diblock copolymers
• surfactants

The diblock copolymer poly(methyl methacrylate)-b-poly(sodium sulfonated glycidyl methacrylate) (PMMA-b-PSGMA) was end-attached by its hydrophobic block (PMMA) onto mica hydrophobized by a stearic trimethylammonium iodide (STAI) layer, to form a polyelectrolyte brush immersed in water. With a surface force balance (SFB), we extended earlier measurements between two such brush layers for the case of normal and shear forces at different shear rates, surface separation, and compressions between one mica surface coated with STAI or a STAI-diblock layer against a bare mica surface. After coating one of the surfaces with STAI, a long range attraction that results in a jump into an adhesive flat contact between the hydrophobic and hydrophilic surfaces was observed. A very different behavior was seen after forming the polyelectrolyte brush on the STAI-coated surface. The long range attraction was replaced by repulsion, accompanied by very low friction during shear (ca. three orders of magnitude lower than with adsorbed polyelectrolytes). On further compression, a weak attraction to the adhesive contact was observed. From the final surface-surface contact separation, we deduce that most of the polyelectrolyte diblock brush layer was squeezed out from the gap, leaving the STAI layer and a small amount of the polymer attached to the surface. Stick-sliding behavior was seen while applying shear, suggesting a dissipation mechanism caused by the trapped polyelectrolyte.

• 出版日期2005-1-15