科研之友
微信
新浪微博
Facebook
分享链接
摘要
RATIONALEHigh-precision stable isotope measurements in gas-source isotope ratio mass spectrometry are generally carried out by repeated comparison of the composition of an unknown sample with that of a working gas (WG) through a dual-inlet (DI). Due to the established DI protocols, however, most of the sample gas is wasted rather than measured, which is a major problem when sample size is limited. Here we propose a new methodology allowing the measurement of a much larger portion of the available sample. METHODSWe tested a new measurement protocol, the long-integration dual-inlet (LIDI) method, which consists of a single measurement of the sample for 200 to 600seconds followed by a single measurement of the WG. The isotope ratios of the sample are calculated by comparison of the beam ratios of the WG and sample at equivalent intensities of the major ion beam. RESULTSThree isotopically very different CO2 samples were analyzed. The LIDI measurements of large samples (50 to 100 mu mol of CO2) measured at quasi-constant beam sizes, and of small samples (1.5 to 2 mu mol of CO2) measured in micro-volume mode, generated results that are indistinguishable from the standard DI measurements for carbon, oxygen and clumped isotope compositions. The external precision of 47 using the LIDI protocol (similar to +/- 0.007 parts per thousand) is similar to that of the state of the art DI measurements. CONCLUSIONSFor traditional and clumped isotope measurements of CO2, the LIDI protocol allows the measurement of a much larger portion of the sample gas rather than only similar to 20 % of it. In addition, the sample can be measured at higher signal intensity and for longer time, allowing the measurement of smaller samples while preserving precision. We suggest that other gases commonly used for stable isotope measurements with gas-source mass spectrometry would also benefit from this new protocol.
- 出版日期2014-7-15
- 单位北京大学
