Process modeling and toolpath optimization for five-axis ball-end milling based on tool motion analysis

作者：Zhang, Liqiang^*

来源：International Journal of Advanced Manufacturing Technology, 2011, 57(9-12): 905-916.

DOI：10.1007/s00170-011-3354-y

• Five-axis
• Process modeling
• Toolpath optimization
• Kinematics analysis

In free-form surface machining, the prediction of five-axis ball-end milling forces is quite a challenge due to difficulties of determining the underformed chip thickness and engaged cutting edge. Part and tool deflections under high cutting forces may result in poor part quality. To solve these concerns, this paper presents process modeling and optimization method for five-axis milling based on tool motion analysis. The method selected for geometric stock modeling is the dexel approach, and the extracted cutter workpiece engagements are used as input to a force prediction. The cutter entry-exit angles and depth of cuts are found and used to calculate the instantaneous cutting forces. The process is optimized by varying the feed as the tool-workpiece engagements vary along the toolpath, and the unified model provides a powerful tool for analyzing five-axis milling. The new feedrate profiles are shown to considerably reduce the machining time while avoiding process faults.

• 出版日期2011-12
• 单位上海工程技术大学