The use of nanometer tetrabasic lead sulfate as positive active material additive for valve regulated lead-acid battery

作者：Lang Xiaoshi; Wang Dianlong^*; Hu Chiyu; Tang Shenzhi; Zhu Junsheng; Guo Chenfeng

来源：Journal of Power Sources, 2014, 270: 9-13.

DOI：10.1016/j.jpowsour.2014.07.101

• Lead acid battery
• Nanometer tetrabasic lead sulfate
• Effective lead dioxide conversion rate
• Discharge specific capacity
• Cycle life

Conventional tetrabasic lead sulfate used as positive active material additive shows the results of the low effective lead dioxide conversion rate due to the large grain size and crossed the crystal structure. In this paper, we study on a type of nanometer tetrabasic lead sulfate. Through the XRD and SEM test and Material Studio software calculation, the purity of tetrabasic lead sulfate is very high, the grain size of the nanometer 4BS is almost unanimous, and can be controlled below 200 nm. When charged and discharged in 1.75 V-2.42 V with the current density of 40 mA g(-1), 80 mA g(-1) and 160 mA g(-1), the effective lead dioxide conversion rate of nanometer 4BS after formation can achieve to 83.48%, 71.42%, and 66.96%.
Subsequently, the nanometer 4BS as additive is added to positive paste of lead-acid battery. When the batteries are tested galvanostatically between 1.75 V and 2.42 V at 0.25 C charge and 0.5 C discharge rates at room temperature. The ratio of adding nanometer 4BS is 0%, 1% and 4% and the initial discharge specific capacities are 60 mAh g(-1), 65 mAh g(-1) and 68 mAh g(-1). After 80 cycles, the initial discharge capacity of positive active material with 1% nanometer 4BS decreased less than 10%, while adding 4% nanometer 4BS, the initial discharge capacity doesn't decrease obviously.

• 出版日期2014-12-15
• 单位哈尔滨工业大学